Gravity Wall-Mount...
HP HWMB 01 B
This wall-mount hanger lets you put your headphones in easy reach. It features two convenient slots to keep your headphone cables neat and tidy.
På lager
.
Filtrer efter
Status
Mærker
Pris
99,00 kr. - 4.249,00 kr.
Der er 5 varer.
HP HWMB 01 B
This wall-mount hanger lets you put your headphones in easy reach. It features two convenient slots to keep your headphone cables neat and tidy.
På lager
In Stereo mode, the L/R input signal is fed to the left and right earphones while the volume level is set by the Stereo/Left control. The front panel inputs provide simultaneous connection of two headphones in parallel. In Mono mode, the left and right channels are summed, and the resulting mono signal is fed to both the left and right earphones. Again, volume is governed by the Stereo/Left control. In Dual Mono mode, the left and right channels can be used independently with individual level controls for the left and right earphones.
The PHDA02 operates with all headphones with an impedance of 8 up to 200 Ohms. Impedance matching is achieved by a specially designed switchable transformer. Uncommon and costly, this solution provides superior performance, dynamic range, and signal- to-noise ratio at all loads.
Combo input sockets allow for balanced XLR and unbalanced TS headphone connection while parallel XLR outputs facilitate daisy chaining multiple units. The integrated power supply operates with mains from 100 VAC to 240 VAC.
The PHDA02 is equipped with low-noise op amps, and the output amplifiers' discrete power transistors are mounted on heatsinks. Dimensions are 1 U 9.5".
På fjernlager
This hanger clamps to any mic stand to put your headphones in easy reach. It features two convenient slots to keep your headphone cables neat and tidy, and the plastic set screw tip protects the stand's finish.
På fjernlager
Designed for both home and professional use, this elegant table-top headphones stand securely holds up to two large sets of headphones. Convenient slots on the holder facilitate convenient and tidy routing and storage of cables or ear buds. The stand features a die-cast aluminium base and tower construction, whereby the holder itself is made of plastic with a rubberised finish.
På fjernlager
This hanger clamps to any desk with 5 to 45 mm thickness to put your headphones in easy reach. It features two convenient slots to keep your headphone cables neat and tidy, and the plastic set screw tip protects your desk's finish.
På fjernlager
Vi bruger cookies til at forbedre vores tjenester, give personlige tilbud og forbedre din oplevelse. Hvis du ikke accepterer valgfrie cookies nedenfor, kan din oplevelse blive påvirket. Hvis du vil vide mere, så læs venligst cookiepolitikken.